BRP Evinrude E-Tec Series Service Manual page 324

GEARCASE
DISASSEMBLY
"O," "L," "M" T
AND
Refer to DISASSEMBLY on p. 314 for driveshaft
removal.
To separate the upper driveshaft (if needed) from
the lower driveshaft, remove the roll pin. Replace
the damaged component.
To assemble the driveshaft, install new driveshaft
retainer into the groove of the upper driveshaft.
322
G
YPE EARCASES
Install the upper driveshaft into the lower drive-
shaft, aligning the holes in the driveshaft retainer
and the lower driveshaft.
Install the roll pin to the specified dimension.
29337
1
1. Roll pin
29338
29330
0.125 in.
(3.2 mm)
DR4610