BRP Evinrude E-Tec Series Service Manual page 165

115,150,175,200 hp, 60 v models

Hide thumbs Also See for Evinrude E-Tec Series:

Table of Contents

Remove the two thru-bolts. Mark the end cap ori-

entation, and remove the cap.

Gently tap the starter frame with a rubber mallet to

Find the insulator cap (end of the shaft or inside

the end cap). Inspect and replace, if necessary.

ELECTRIC STARTER SERVICING

Note the alignment marks by the positive terminal

stud. Hold the armature in place, and slide the

frame away from the gear housing.

Slowly remove the armature and thrust washer.

Do not lose the brush springs.

ELECTRICAL AND IGNITION

Chapters

Table of Contents