BRP Evinrude E-Tec Series Service Manual page 311

Remove the forward screw with the washer, and
remove middle screw.
2
1. Forward screw
2. Middle screw
Remove the four gearcase retaining screws.
1. Gearcase retaining screws
Remove the gearcase assembly from the exhaust
housing, being careful not to bend the shift rod or
damage the water tube. The lower inner exhaust
housing may come out with the gearcase.
Installation
During service, the outboard may drop
unexpectedly.
always support the outboard's weight with
a suitable hoist or the tilt support bracket
during service.
1
IMPORTANT:
motor, shift rod adjustment MUST be checked.
Refer to SHIFT ROD ADJUSTMENT on p. 314.
COA3139
Coat the driveshaft splines with Moly Lube. DO
NOT coat top surface of the driveshaft because
lubricant may prevent seating of the driveshaft in
the crankshaft.
1
001990
Apply Adhesive 847 to the lower exhaust housing
seals' inner surfaces. Position two new seals on
the housing. Apply Triple-Guard grease to the
seals' outer surfaces and position the housing on
the gearcase.
TYPICAL
1. Lower exhaust seals
GEARCASE
REMOVAL AND INSTALLATION
WARNING
Avoid personal
Before installation of gearcase on
injury;
30385
1
12
001985
309