BRP Evinrude E-Tec Series Service Manual page 71

Observe oil flow through the oil distribution hoses.
1. Oil distribution hoses (7)
Make sure that oil flows through the rear oil distri-
bution manifold to the cylinder block fittings.
1. Rear oil distribution manifold
INSTALLATION AND PREDELIVERY
Small bubbles are acceptable. Large bubbles
must be eliminated through a continued priming
process.
1
1
3
1. Oil distribution hose
2. Small bubbles
3. Large bubbles
004965
IMPORTANT:
hoses on the powerhead should fill with oil as the
air is purged from the lines.
Repair any fuel or oil leaks.
1
The oiling system can also be primed using the
Self-Winterizing feature if diagnostic software is
not available. Refer to STORAGE on p. 91.
005271
FUEL AND OIL PRIMING
2
All clear "blue" oil distribution
2
004398
69