BRP Evinrude E-Tec Series Service Manual page 242

POWERHEAD
REMOVAL
Disconnect power trim connectors.
1
1. Tilt limit switch connector
2. Sending unit connector
1. Tilt relay connector
V4 M
ODELS
Disconnect electrical harness from exhaust valve
actuator. It is not necessary to remove actuator
from exhaust housing.
1
1. Actuator connector
240
A M
LL ODELS
Disconnect water overflow hose from vapor sepa-
rator. Remove clamps and muffler assembly from
rear of powerhead.
1
2
005254
1. Overflow indicator hose
2. Muffler clamps
Remove the four small powerhead screws, seven
large powerhead screws, and the upper mount
screws.
1
2
005255
1
1. Large powerhead screws
2. Small powerhead screws
3. Upper mount screws
Install Lifting Tool, P/N 342672, on crankshaft.
Tighten mounting screw securely using an
005247
2
005243
3
2
005273