Crankcase - BRP Evinrude E-Tec Series Service Manual

POWERHEAD
DISASSEMBLY
Remove shoulder screw from shift arm and retain-
ing screw from shift rod lever. Slide entire shift
linkage assembly from crankcase.
1
1. Shift arm screw
2. Shift lever screw
Remove the throttle body and reed plate assem-
blies. Refer to INTAKE MANIFOLD on p. 196.
Remove pressure valve assembly. Refer to
PRESSURE RELIEF VALVE SERVICING on
p. 233.

Crankcase

Remove crankcase flange screws.
1
1. Flange screws (12 on V4; 16 on V6)
242
Loosen in stages and remove the main bearing
screws.
1
2
1. Main bearing screws (6 on V4; 8 on V6)
005294
Using a 1/8 in. diameter pin punch, push crank-
case taper pin toward intake manifold side.
IMPORTANT:
any other tool that could jam in or damage the
taper bore when removing the pin.
1
Separate crankcase and cylinder block. It may be
necessary to tap on crankshaft with a rawhide or
rubber mallet to loosen.
005306
Do not use a tapered punch or
1
005313
005305