BRP Evinrude E-Tec Series Service Manual page 37

Installation Guidelines
Install the appropriate remote control following all
instructions provided with the remote control.
Make sure the following items are checked:
Correct length control cables and wiring har-
•
nesses
Proper type and quality of cables and wiring
•
harnesses
Correct routing of cables and harnesses
•
Appropriate slack in front of the outboard for
•
remote control cables
Proper routing of cables to prevent kinking
•
Positioning and securing of cables and har-
•
nesses along their lengths to prevent movement
or damage
Typical transom-mounted outboard installations
require a 12 in. (30 cm) cable loop at the front of
the outboard when the cables are routed from the
side of the splash well.
1
1. Surface side-mount remote control
2. Cable support
3. 12 in. (30 cm) cable loop at front of outboard
Cables of the proper length, style,
IMPORTANT:
and quality that are correctly installed and
adjusted will eliminate most control-related opera-
tional problems.
2 3
DR4277
INSTALLATION AND PREDELIVERY
SystemCheck™ Monitor
The SystemCheck engine monitor alerts the oper-
ator of certain engine problems. Refer to the
Operator's Guide for detailed information related
to the various warning signals.
Outboards with remote controls
IMPORTANT:
must be equipped with a SystemCheck gauge, I-
Command system, or equivalent engine monitor.
Operating the outboard without an engine monitor
will void the warranty for failures related to moni-
tored functions.
Typical MWS SystemCheck gauges
Typical I-Command gauge
BOAT RIGGING
2
005329
005330
35