REMOVAL AND
INSTALLATION
Removal
Remove port lower engine cover and disconnect
the trim/tilt connectors. Refer to Powerhead
REMOVAL on p. 239.
Remove the rubber grommet from the blue/green
trim/tilt cable connector.
Remove the terminals from the connector by
using a suitable tool to depress the tab. While the
tab is depressed, pull on the wire from the rear of
the connector to release it from the connector.
REMOVAL AND INSTALLATION
Separate the trim/tilt unit wires in the braided tube
to permit removal through the hole in the stern
bracket.
Unscrew the manual release valve, raise the unit,
and lock it in place with the tilt support.
000686
Remove the ground wire from the trim/tilt unit.
000687
1. Ground wire
TRIM AND TILT
25078
27381
1
13
25057
373