Disassembly - BRP Evinrude E-Tec Series Service Manual

115,150,175,200 hp, 60 v models

Hide thumbs Also See for Evinrude E-Tec Series:

Table of Contents

EXHAUST HOUSING

Disassembly

Remove three screws and exhaust valve actuator.

1. Actuator screws

Remove the front and rear screws retaining the

adapter/inner exhaust housing to the exhaust

1. Adapter retaining screws

Lift the adapter/inner exhaust housing out of the

exhaust housing.

Remove the water tube. Inspect water tube grom-

met and replace if necessary.

1. Water tube grommet

Remove circlip and washers from exhaust valve

shaft on starboard side of inner exhaust housing.

Remove exhaust valve shaft and washer from port

side of inner exhaust housing.

Remove exhaust valves from inside the inner

exhaust housing.

Table of Contents