BRP Evinrude E-Tec Series Service Manual page 63

Install trunnion cover and screw. Tighten retaining
screw to a torque of 60 to 80 in. lbs. (7 to 9 N·m).
1
1. Shift cable retainer clip and washer
2. Shift cable trunnion
Throttle Cable Installation and Adjustment
Rotate the propeller shaft and shift control lever to
FORWARD, then pull control lever half-way back
to NEUTRAL.
Position throttle cable on throttle lever pin and
install washer and retainer clip.
1
1. Throttle cable retainer clip and washer
INSTALLATION AND PREDELIVERY
With throttle cable attached to the throttle linkage,
pull cable to remove slack and ensure that idle
stop of the throttle linkage is against the crank-
case.
2
004956
1. Throttle linkage, idle stop against crankcase
Adjust the throttle cable trunnion to align with the
trunnion block. Place the cable trunnion in the
trunnion block.
IMPORTANT:
the throttle linkage firmly contacts the crankcase
when the remote control is in the IDLE position.
The roller on the cam follower should spin freely.
Install the trunnion cover and screw. Tighten the
retaining screw to a torque of 60 to 80 in. lbs. (7 to
9 N·m).
004957
1. Trunnion cover and screw, throttle cable
OUTBOARD RIGGING
Make sure that the idle stop on
2
1
004947
1
004958
61