BRP Evinrude E-Tec Series Service Manual page 377

Install external snap rings onto upper pin with
sharp edge facing out.
Place trim/tilt wires in braided tube and install
through hole in the stern bracket.
Attach the ground wire to the trim/tilt unit.
1
1. Ground wire
REMOVAL AND INSTALLATION
Release the tilt support and lower the outboard.
Torque the manual release valve to 45 to 55 in.
lbs. (5.1 to 6.2 N·m).
25064
Install connector on trim/tilt cable and reconnect
trim connectors to engine wire harness.
25079
Install port lower engine cover. Refer to Power-
head INSTALLATION on p. 262.
25057
TRIM AND TILT
27381
002152
13
375