BRP Evinrude E-Tec Series Service Manual page 341

115,150,175,200 hp, 60 v models

Hide thumbs Also See for Evinrude E-Tec Series:

Table of Contents

Washer must be snapped into recess of pinion

The inside taper of the pinion

gear and the driveshaft taper MUST be com-

pletely free of grease. Clean the tapers with

Cleaning Solvent. Use a shop towel free of grease

Lightly coat the threads of a new pinion nut with

outboard lubricant and install on the driveshaft

using Pinion Nut Starting Tool, P/N 342216. Turn

the driveshaft by hand to engage the nut. Hand

tighten pinion nut and remove the pinion nut start-

ing tool. Proceed to next step and then torque pro-

Install washers on the driveshaft bearing housing

screws. Apply Gasket Sealing Compound to the

threads of the screws. Install screws and torque to

120 to 144 in. lbs. (13.6 to 16.3 N·m).

1. Driveshaft bearing housing screws

Use Driveshaft Holding Socket, P/N 311875, Pin-

Retainer, P/N 341438, to torque the pinion nut to

100 to 110 ft. lbs. (136 to 149 N·m).

1. Holding socket

2. Pinion holder

Chapters

Table of Contents