Motor Installation - BRP Evinrude E-Tec Series Service Manual

TRIM AND TILT
SERVICING – THREE PISTON SYSTEM
P/N 912084. Torque cap to 58 to 87 ft. lbs. (79 to
118 N·m).

Motor Installation

Position the pump manifold so the pump mounting
surface is level. Install the coupler into the pump.
1
1. Coupler
Fill the pump cavity with Power Trim/Tilt & Steer-
ing Fluid up to the top of the two bosses. Rotate
the coupler clockwise and then counterclockwise
until no more air bubbles come out of the pump.
1
1. Bosses
386
Install the filter screen.
1. Filter screen
41870
Lubricate and place a new O-ring on the motor.
Make sure the cable is on the transom side of the
unit; align the coupler slot with the motor shaft.
Place the motor on the pump manifold assembly.
1
2
1. O-ring
41852
2. Cable
Install the four motor screws. Torque the screws
to 35 to 52 in. lbs. (4.0 to 5.9 N·m).
41854
1
41856
41857
41858