Fuel Manifolds - BRP Evinrude E-Tec Series Service Manual

FUEL SYSTEM
FUEL COMPONENT SERVICING

Fuel Manifolds

Removal
Disconnect the battery cables at the battery.
Relieve fuel system pressure. Refer to Relieving
Fuel System Pressure on p. 189.
Note the locations and position-
IMPORTANT:
ing of all spark plug leads and retainer clips prior
to disassembly.
Remove clamps and disconnect the fuel mani-
folds as follows:
Fuel supply manifold to circulation pump
•
Fuel return manifold to vapor separator
•
1
1. Fuel supply manifold
2. Fuel return manifold
Remove fuel manifold retainer screw and remove
retainer from fuel injector.
1
2
1. Retainer screw
2. Fuel supply manifold fitting
3. Fuel return manifold fitting
192
Disconnect fuel manifold fittings from fuel injector
ports, then remove the manifold assembly(s).
Installation
Check condition of sealing O-rings on fuel mani-
fold fittings. Lubricate O-rings with outboard lubri-
cant and insert fuel manifold fittings into injector.
Both fittings must be fully seated into the injector
fuel ports.
Install retainer and screw. Retainer must engage
the outer groove of the manifold fittings.
1
1. Retainer
2. Manifold fitting groove
2
005341
1
2
3
1. Retainer screw
2. Fuel supply manifold fitting
3. Fuel return manifold fitting
Reconnect spark plug leads and battery cables.
Start outboard briefly to pressurize fuel system.
Turn outboard OFF and inspect all fuel system
005337
components for leaks.
Install lower engine covers and air silencer.
2
005342
3
005337