BRP Evinrude E-Tec Series Service Manual page 296

115,150,175,200 hp, 60 v models

Hide thumbs Also See for Evinrude E-Tec Series:

Table of Contents

STERN BRACKET

Remove the anode.

Remove the swivel bracket. Inspect and, if neces-

sary, replace the tilt tube bushings.

1. Tilt tube bushing

Remove the trim sender unit from the port stern

bracket and pull its wires through the braided

Remove the tilt limit switch and retainer from the

swivel bracket.

1. Tilt limit switch

Disconnect the trail lock spring and remove it from

the swivel bracket. Remove trail arm retainer.

1. Trail lock spring

2. Trail arm retainer

Remove the trail lock arm and bushings from the

swivel bracket.

1. Trail lock bushing

Chapters

Table of Contents