Adjustments - BRP Evinrude E-Tec Series Service Manual

115,150,175,200 hp, 60 v models

Hide thumbs Also See for Evinrude E-Tec Series:

Table of Contents

TRIM AND TILT

ADJUSTMENTS

Fill the oil reservoir up to the fill plug with

Biodegradable

Evinrude/Johnson

Install and tighten the fill plug. Do not torque the

plug at this time.

1. Reservoir cap

Run the motor, then recheck oil level. Cycle the

unit several times and check the oil level when the

cylinder is fully extended. Oil should be level with

bottom of fill port. Install and tighten the fill plug to

a torque of 45 to 55 in. lbs. (5 to 6 N·m).

Refer to Trim Sending Unit Adjustment on

Refer to Tilt Limit Switch Adjustment on p. 75.

Table of Contents