BRP Evinrude E-Tec Series Service Manual page 267

Install rear shroud and flywheel cover.
Install the lower engine covers and tighten the
screws.
1
1. Lower cover screws
Connect trim/tilt switch connector.
005248
IMPORTANT:
before returning outboard to service:
Index all spark plugs. Refer to Spark Plug
•
Indexing on p. 160.
Use the Evinrude Diagnostics Software pro-
•
gram to initiate powerhead break-in. Refer to
Powerhead Break-In on p. 109.
Prime fuel system. Refer to Fuel System Prim-
•
1
ing on p. 66.
Prime oiling system. Refer to Oiling System Oil
•
Supply Priming on p. 68.
Adjust timing pointer and check engine timing.
•
Refer to TIMING ADJUSTMENTS on p. 157.
005242
POWERHEAD
INSTALLATION
Perform the following procedures
005246
10
265