Driveshaft Service - BRP Evinrude E-Tec Series Service Manual

115,150,175,200 hp, 60 v models

Hide thumbs Also See for Evinrude E-Tec Series:

Table of Contents

Driveshaft Service

To separate the upper driveshaft

from the lower driveshaft, the upper retainer must

be removed and upper driveshaft must slide down

into lower driveshaft.

Remove the four driveshaft bearing housing

screws with washers and bearing housing.

1. Driveshaft bearing housing screws

Remove upper retainer

Force upper driveshaft into lower driveshaft. This

moves lower retainer on stepped groove of lower

driveshaft. Refer to diagram below.

Upper Driveshaft Removal

Lift and remove upper driveshaft from lower drive-

Table of Contents