BRP Evinrude E-Tec Series Service Manual page 226

OILING SYSTEM
OIL COMPONENT SERVICING
Reconnect the electrical connector.
Use oil primer bulb to purge oil
IMPORTANT:
supply hose before reconnecting hose to oil
pump.
Reconnect oil supply hose to the inlet fitting of oil
pump. Fasten with Oetiker clamp.
2
1
TYPICAL
1. Oil supply hose
2. Oetiker clamp
Make sure oiling system is primed. Check oil flow
through oil distribution hoses. Check oil system
operation and routing of oil hoses. Refer to PRIM-
ING on p. 215.
Run the outboard and check for leaks.
Repair any oil leaks and any kinked or misrouted
hoses.
Reinstall the air silencer and engine cover.
224
005346