BRP Evinrude E-Tec Series Service Manual page 248

115,150,175,200 hp, 60 v models

Hide thumbs Also See for Evinrude E-Tec Series:

Table of Contents

Remove O-ring from crankshaft sleeve and

inspect it. Replace the O-ring if it is not in good

Inspect the crankshaft sleeve and replace if nec-

P/N 432128, and Large Puller Jaws, P/N 432129.

Remove the lower main bearing only if it needs

to be replaced. Use external retaining ring pliers

to remove the lower bearing retaining ring.

Using an appropriate bearing separator, support

the bearing, place separator flats against the

bearing, and press off the crankshaft.

Remove and inspect crankcase seal rings. Iden-

tify each ring for installation in original location.

Remove center main bearings and split sleeves

for inspection. Do not mix parts. Note location of

bearings for reassembly.

Chapters

Table of Contents