BRP Evinrude E-Tec Series Service Manual page 338

115,150,175,200 hp, 60 v models

Hide thumbs Also See for Evinrude E-Tec Series:

Table of Contents

Install pinion gear in gearcase housing

Install driveshaft with thrust bearing, thrust

washer, and correct shim(s) in gearcase housing.

Position pinion on lower driveshaft.

Position pinion screw in lower driveshaft and

thread into pinion.

ing for support during pinion torque procedure.

Insert Lower Driveshaft Spline Tool, P/N 5007052,

into lower driveshaft.

1. Lower Driveshaft Spline Tool

Insert Lower Driveshaft Wrench, P/N 352877,

through Lower Driveshaft Spline Tool and lower

driveshaft. Seat hex tip of wrench in head of pin-

1. Wrench, hex tip

Wrench is fully seated in head of pinion screw.

Temporarily install bearing hous-

Chapters

Table of Contents