BRP Evinrude E-Tec Series Service Manual page 298

MIDSECTION
STERN BRACKET
Install the two trim rod rollers on the swivel
bracket. Torque to 216 to 240 in. lbs. (25 to 27
N·m).
1
1. Trim rod roller
Install the trail lock and bushings in the swivel
bracket. Torque to 216 to 240 in. lbs. (25 to 27
N·m).
1. Trail lock bushing
Install the trail lock spring in the swivel bracket
and connect the spring to the trail lock.
2
1. Trail lock spring
2. Trail arm retainer
296
Install the tilt limit switch and retainer on the swivel
bracket. Torque screws to 40 to 50 in. lbs. (4.5 to
5.7 N·m).
1
30754
1. Tilt limit switch
2. Retainer
Route the trim sender wires through the braided
tube, and install the sender unit in the port stern
bracket.
1
30755
Install the upper and lower steering shaft bushings
and new seals in the swivel bracket. Both seal lips
face out.
Coat the outside surfaces of seals with Gasket
•
Sealing Compound.
1
30756
2
30758
30760