BRP Evinrude E-Tec Series Service Manual page 218

OILING SYSTEM
PRIMING
Observe oil flow through all oil distribution hoses.
1. Crankcase oil distribution hoses (port side)
Make sure that oil flows through the rear oil distri-
bution manifold to the cylinder block fittings.
1. Rear oil distribution manifold
216
Small bubbles are acceptable. Large bubbles
must be eliminated through a continued priming
process.
1
1
3
1. Oil distribution hose
2. Small bubbles
005348
3. Large bubbles
IMPORTANT:
hoses on the powerhead should fill with oil as the
air is purged from the lines.
Repair any fuel or oil leaks.
1
The oiling system can also be primed using the
Self-Winterizing feature if diagnostic software is
not available. Refer to STORAGE on p. 91.
005271
2
All clear "blue" oil distribution
004398