BRP Evinrude E-Tec Series Service Manual page 157

Lift the electrical harness base out of the way.
Use Flywheel Holder, P/N 771311, or equivalent,
to remove the five flywheel retaining nuts and
washers. Discard the nuts.
1
1. Flywheel retaining nuts
CAUTION
To avoid damage to flywheel magnets, or
injury to fingers, Flywheel service kits,
P/N 434649 and P/N 5007181, must be
used to remove or install the flywheel.
Install bushing from Flywheel Puller Adaptor Kit,
P/N 5007181, on top of crankshaft. Place puller
from Flywheel Service Kit, P/N 434649, over
bushing.
FLYWHEEL AND STATOR SERVICING
Use two 3/8-24x2 in. screws from the adaptor kit
to attach the tool to the flywheel. Two holes are
tapped in the flywheel for the tool.
1
2
005379
1. Puller
2. Bushing
3. Screws - 3/8 - 24 x 2 in. (2)
Turn the center screw of the puller in to lift the fly-
wheel off of the crankshaft.
005380
ELECTRICAL AND IGNITION
3
005369
6
005381
155