BRP Evinrude E-Tec Series Service Manual page 323

115,150,175,200 hp, 60 v models

Hide thumbs Also See for Evinrude E-Tec Series:

Table of Contents

Installation

To install upper driveshaft into lower driveshaft,

position new retainers (circlip type) on upper

driveshaft as shown.

1. Retainer(s)

Hold lower retainer in place and align upper drive-

shaft with lower driveshaft. Force upper driveshaft

down until seated. Make sure upper driveshaft is

locked in place.

Install new seals in driveshaft bearing housing.

Refer to Driveshaft Bearing Housing on p. 326.

Using Driveshaft Seal Protector, P/N 318674,

slide the driveshaft bearing housing onto the

1. Seal protector

Apply Gasket Sealing Compound to the threads of

the screws. Install screws and torque to 120 to

144 in. lbs. (13.6 to 16.3 N·m).

1. Driveshaft bearing housing screws

Chapters

Table of Contents