Driveshaft Service - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

GEARCASE – STANDARD ROTATION
GEARCASE DISASSEMBLY
Locked Driveshaft Removal
The driveshaft to pinion taper is a locking taper. If
necessary, use Driveshaft Puller, P/N 390706, and
Backing Plate, P/N 325867, to break the lock.
Install the tools as shown by clamping them
around the driveshaft. Alternately tighten the two
vertical screws against the backing plate inserted
between the puller and the gearcase until the
driveshaft pops loose from the pinion.
1. Drive shaft
2. Puller
3. Backing plate
If upper driveshaft becomes separated from lower
driveshaft, use Lower
P/N 342681, to remove. Install puller into lower
driveshaft and turn 90° to position hook under pin
in driveshaft. Thread Slide Hammer, P/N 391008,
into puller and remove driveshaft.
282
1
2
3
006879
Driveshaft Puller,
006880

Driveshaft Service

To separate the upper driveshaft (if needed) from
the lower driveshaft, remove the roll pin. Replace
the damaged component.
To assemble the driveshaft, install new driveshaft
retainer into the groove of the upper driveshaft.
Install the upper driveshaft into the lower drive-
shaft, aligning the holes in the driveshaft retainer
and the lower driveshaft.
29337
29338
29330