Tps Calibration; Electric Starter Servicing; Starter Removal - BRP EVINRUDE E-TEC 115 HP 2011 Service Manual

ELECTRICAL AND IGNITION

ELECTRIC STARTER SERVICING

TPS Calibration

Use Evinrude Diagnostics software to tell the
EMM what throttle position sensor voltage is when
the throttle plates begin to open.
Set TPS Calibration after replacing or adjusting
any throttle body or throttle linkage parts.
Remove the air silencer.
Do NOT start the outboard.
On the Settings/Adjustments screen of the diag-
nostics software, click the "Set TPS Calibration"
button.
1
1. TPS Calibration button
While holding the throttle plates closed, advance
the throttle linkage until it stops. The "Measured
TPS Calibration" field on the screen will increase.
Click the "Working" button in the software to cali-
brate the TPS.
Install the air silencer.
116
ELECTRIC STARTER
SERVICING

Starter Removal

IMPORTANT:
while the starter motor and drive are installed on
the powerhead. The cleaning agent could drain
into the starter motor, washing dirt from the drive
into the starter bearings and commutator.
Disconnect the battery cables at the battery.
Remove the starter positive (+) cable from post on
starter.
Remove the four frame and bracket mounting
screws. Remove the starter.
1
008108
Loosen the two nuts used to fasten the starter
bracket. Remove the nuts and bracket.
Do not clean the starter drive
2
005373
30374