Locking The Avaya Codec; Changing Display Resolution - Avaya 1050 Installation Manual

8. An Initial Configuration screen appears and prompts you to configure the system.
Refer to "Initial Configuration" on page 6 and the information you collected there
previously to guide you through your configuration choices. Use the arrow keys on the
remote control to navigate the preferences that appear in the initial configuration
screens. Icons that appear at the bottom of each screen correspond to keys on the
remote control and indicate what operations are available for the screen or a selected
object.
If the initial configuration screen does not appear and the display is blank, refer to
"Troubleshooting Installation Issues" on page 23.
The bottom of the screen contains the system status bar and the navigation bar. The
system status bar indicates system and network status. When the system is booting,
status also appears at the top of the REDIAL list to indicate the current state of the
system. See "Status Icons" on page 26 for an explanation of status icons you may
encounter.

Locking the Avaya Codec

You can lock the Avaya codec with a secure loop to prevent physical removal of the device.
For assistance, contact Avaya Customer Support.

Changing Display Resolution

The primary output onAvaya 1050 defaults to 720p60 and will work with any 720p HDMI
display.
To change display resolution, navigate to Administrator Preferences : Appearance :
Displays and choose Display 1 Resolution. You can change the resolution to 1920x1080i60
or 1920x1080p30 and it will work with most 1080 HDMI displays. However, some 1080p
displays will not work with 1080p30 mode and the display may be blank. In this case you
must configure the display resolution from either the Avaya Video Conference Phone 1000
(refer to "Configuring Display Output from Avaya Video Conference Phone 1000" on
page 23) or from the web administration interface for the Avaya system (refer to the Avaya
Video Communications Systems Administrator Guide). Avaya recommends that before you
change the display resolution to 1920x1080p30, ensure that you can access the Display 1
Resolution preference using one of these methods.
Note: To access the web administration interface for the system, HTTP access must be
set to Enabled (the default) in Administrator Preferences : Security : General
and you must identify the IP address of the Avaya system. The IP address appears
in the upper right corner on the main page of the user interface.
Avaya 1050 Installation Guide 18