Table of Contents
Advertisement
Page 24 - Analogue Devices
ALOG Circuit Settings
Page 24 - Inserting Device Cassettes
38DHB0002UKDJ – Issue 3 (12/00)
For analogue devices (trunk, two-wire terminals and AC15 circuits), an extra Trunk
or Station menu option called Analogue control data is accessible. The settings
entered for each analogue circuit must match those required by the line or
equipment provider.
To alter the settings for an ALOG cassette circuit :
1. From the Administration menu, select Trunk (AC15 or analogue trunk) or
Station (two-wire terminal circuit) and enter the device's directory number.
2. Select Analogue control data.
3. Alter only those settings indicated by the line provider/ equipment manufacturer
or as below.
To set a two-wire Station circuit for MF or LD dialling :
Not all two-wire circuits support LD operation, nor is it approved for all countries.
Consult with Avaya for full details.
1. Select Station and then Analogue control data.
– For MF dialling, set the Recall detect minimum to 5.
– For LD dialling, set the Recall detect minimum to 9.
To set the dialling timeout on a POT :
This controls the delay between digits before the POT accepts no further dialling.
1. Select Station and then Analogue control data.
2. Select Dialling timeout and enter a value (1 to 255 100ms).
To set an AC15 circuit for MF or 10PPS :
1. Select Trunk and then Analogue control data.
– For MF dialling, set the Signalling type to DTMF.
– For 10PPS dialling, set the Signalling type to pulse.
To set the signalling on an ALOG trunk circuit :
1. Select Trunk and then Analogue control data.
– For Clearing mode set to unguarded or disconnect, set the
Disconnect/Guarded clear to 45.
– For Clearing mode set to guarded, set Disconnect/Guarded clear to 2.
Inserting Device Cassettes
Programming Manual
INDeX 9.1
Advertisement
Table of Contents
