Verifying The Mcu Installation - Avaya Scopia Elite 6000 MCU Series Rack Mounting Manual

Setting up the Device
2. Connect the other end of the power cable to the AC power.
3. Use a serial cable to connect a PC to the device's serial port. This connection is required for
local configuration and maintenance.
Important:
Do not connect a screen or a keyboard to the device directly. Define the device's basic
settings via the serial connection only.
Related links
Setting up the Device

Verifying the MCU Installation

About this task
After you installed the device and performed its initial configuration, you need to verify that it is
installed and configured correctly.
Procedure
1. On the front panel, verify that the power LED is lit green.
2. Verify that the status LED is lit green (selected models only).
3. Check the network connection by verifying that the Ethernet activity LED is lit green.
January 2017
on page 14
Figure 25: Locating the front panel LEDs
Rack Mounting Guide for Avaya Scopia Elite 6000 MCU
Comments on this document? infodev@avaya.com
30