Removing A Battery From A Talkman A500, T5-Series Or T2-Series Device - Honeywell Vocollect Hardware Reference Manual

4. Push the back of the battery into place.
You will hear a click when the battery is in place.
CAUTION: Do not force the battery into the compartment. You may damage the battery or the device. If
the battery does not snap easily into place, reposition the battery in the compartment and try again.
Make sure the battery is firmly in place and can't be removed without pressing the battery release button.
Warning: Replace a battery only with another battery that has been authorized by Honeywell for the product
you are using. Use of an unqualified battery may present a risk of fire, explosion, leakage, or other hazard.
See also Honeywell Battery Safety

Removing a Battery from a Talkman A500, T5-Series or T2-Series Device

Make sure the Talkman device is off.
CAUTION: Do not remove the battery until the LED indicator is off. If you remove the battery when the
device is on or sleeping, any data collected could be lost.
1. Hold the device in one hand with the battery compartment facing toward you.
2. Press the battery release button all the way down until the top of the battery pops up from the battery
compartment.
3. Lift the battery out of the compartment.
Figure 27: Properly Inserting a Battery
Figure 28: Removing the Battery From a Device
| Talkman A500 | 85