Charging An A700 Battery In A Device; Charging An A700 Device Battery; Inserting A Battery Into A Talkman A700 Device - Honeywell Vocollect Hardware Reference Manual

• Environmental specifications: The battery pack halves are sonically welded together to protect the internals from
water and dust. The battery functions properly in the following conditions:
Operation Temperature: -30°C to 50°C (-22°F to 122°F)
Storage Temperature: -30°C to 60°C (-22°F to 140°F)
Humidity: 95% condensing
Rain/dust: IP67
Battery Notifications
Battery warnings for a Talkman battery occur at the following levels:
• First warning = 30 minutes remaining until empty
• Critical warning = 0 minutes remaining until empty

Charging an A700 Battery in a Device

1. Remove the device from the belt clip.
2. Disconnect any wired peripherals.
3. Insert the device into an open slot on the charger, ensuring that the battery contact side of the device is placed
against the battery contact side of the slot.
4. After the device has been placed into the charger, make sure that the device state indicator on the device turns on a
solid yellow.
a) If the indicator does not turn on after 30 seconds, remove the device from the charger slot and then place it into
the slot again.
b) If the indicator still does not turn on, try another charger slot.
CAUTION: Do not attempt to place the device into the charger unless you have first disconnected the
headset and any other peripheral devices. Do not remove the battery from the device when placing a device
into a charger.

Charging an A700 Device Battery

Note:
• A battery is fully charged and can be removed from the charger when the ring LED indicator light for that
port on the charger is green.
• If you insert a fully charged battery into a charger, the charger will analyze the battery's status and indicate
charge status immediately.
1. Make sure the battery charger is powered. To power on the charger, connect the power supply to the charger and a
power source. The LED indicator light at the bottom right of the charger face panel should be solid green.
2. Power off the device.
3. Remove the battery from the device.
4. Hold the battery with the pins downward and facing away from you, and push it onto an empty port on the battery
charger until it snaps into place.
5. When the ring LED indicator turns a solid green, the battery is fully charged. Pull the battery off the charger port
to insert it into an A700 device.

Inserting a Battery into a Talkman A700 Device

Make sure the battery to be inserted is fully charged.
| Talkman A700 | 67