Removing An A500, T2-Series Or T5-Series Device From A Charger; Inserting A Battery Into A Talkman A500, T5-Series Or T2-Series Device - Honeywell Vocollect Hardware Reference Manual

CAUTION: If the LED indicator on a device is blinking red, do not remove the device from the charger.

Removing an A500, T2-Series or T5-Series Device From a Charger

The device is ready to use when the LED indicator on the device is blinking green. If the LED is blinking red, the
device is not ready to be used.
Important: If a device continuously displays a solid red light, contact your system administrator.
1. Make sure that the device is ready to use.
2. Pull up on the device to remove it from the device charger.

Inserting a Battery into a Talkman A500, T5-Series or T2-Series Device

Make sure the battery to be inserted is fully charged.
1. Hold the Talkman so that the red and yellow ports are facing away from you.
2. Hold the battery with the pins facing away from you and so that the Vocollect logo is on top.
3. Place the battery in at an angle, pins end first.
4. Push the back of the battery into place.
You will hear a click when the battery is in place.
CAUTION: Do not force the battery into the compartment. You may damage the battery or the device. If
the battery does not snap easily into place, reposition the battery in the compartment and try again.
Make sure the battery is firmly in place and can't be removed without pressing the battery release button.
Figure 90: Removing a Device from a Charger
Figure 91: Properly Inserting a Battery
| Talkman T2 Series | 133