Removing The Srx2 Electronics Module From A Headband; Srx2 Compatibility - Honeywell Vocollect Hardware Reference Manual

3. Push the electronics module into the hub pocket until it is firmly seated.

Removing the SRX2 Electronics Module from a Headband

Important: Do not squeeze the battery latches on the sides of the electronics module while removing it from
the headband. The battery may be inadvertently released from the electronics module.
1. Grasp the SRX2 electronics module with one hand, pressing your thumb and fingertips into the gap between the
electronics module and earpiece hub.
2. With the other hand, hold the headband by the earpiece hub.
3. Pull the electronics module away from the earpiece hub.

SRX2 Compatibility

Honeywell has tested the SRX2 Wireless Headset with the following devices and Vocollect Voice Software versions.
Support and compatibility of the SRX2 headset is not limited to these products, but the customer assumes risks related
to untested configurations.
Device
Vocollect Talkman A700
Vocollect Talkman A500 and Talkman A500 VMT
Vocollect Talkman T5 and Talkman T5m
Windows XP PC and other supported display terminals
Intermec ® CK3
Intermec CK3X
Intermec CV41
Psion WORKABOUT Pro G2
Psion WORKABOUT Pro (WAP3)
Psion NEO
Figure 125: Attaching the electronics module
Vocollect Voice Software
VoiceClient
VoiceCatalyst
VoiceClient
VoiceCatalyst
VoiceClient 3.8 and newer
VoiceCatalyst MP for Windows XP 1.0 and newer
VoiceClient MP 2.0 and newer
VoiceClient MP 2.1 and newer
VoiceCatalyst MP 1.0 and newer
VoiceClient MP 2.0 and newer
| Honeywell Wireless Headsets | 178
® 3.9 and newer
2.0 and newer
®
® 3.8 and newer
® 1.1 and newer