Connecting The A700/T5 Vmt Device To A Vehicle's Power Source - Honeywell Vocollect Hardware Reference Manual

8. Place the power supply in a place out of the way, such as under the dashboard of a fork lift, and attach it to a
secure surface with cable ties. Alternatively the power supply could be secured by bolting it using the mounting
slots.
Figure 74: Power Supply Attached to a Secure Surface on the Vehicle
9. Run the cable that connects the battery adapter to the power supply from the power supply to the location where
the A500/T5 VMT will be mounted
10. Connect the yellow wire to the battery adapter by attaching the connector and tightening the nut.

Connecting the A700/T5 VMT Device to a Vehicle's Power Source

You will need the following equipment:
• Two fuse holders from Cooper Bussman. Honeywell recommends using a Cooper Bussmann HFA series in line
waterproof fuse.
• Two fuses. Honeywell recommends a 4A 250V SLO BLO
• Three spade connectors
• Four small cable ties
• Fasteners
Honeywell recommends choosing unswitched power as the source for the power supply. This will allow Talkman
devices to be powered for software updates as well as prevent Talkman devices from accidentally being unpowered if
the vehicle is quickly switched off unintentionally.
1. Remove all power sources from the vehicle.
2. Remove any excess length from the input cable that comes from the power supply.
3. Connect the fuses to the cable near to the battery end of the cable. Remove approximately 4 inches of the outer
insulation from the cable.
4. Expose approximately 10mm of copper on the positive and negative wires.
Figure 73: Cables Attached to the Power Supply
™
fuse.
| Talkman T5 Series | 119