Positioning The Talkman A500/T5 Vmt; Install The Mounting Brackets - Honeywell Vocollect Hardware Reference Manual

Figure 69: Clamp Mounting Parts
Figure 71: Battery Adapter
Note: You may provide your own power supply, but it must supply 12-15V at 1 Amp and must be limited
to less than 250VA (Watts). If you chose to provide your own, you are still required to purchase the battery
adapter cable and battery adapter for final connection to the A500 or T5-Series device.
Note: This configuration does not require you to connect the A500 or T5-Series device to the vehicle's power
source. If desired, for operational reasons, A500 or T5-Series devices may be used in VMT configuration
using a Honeywell battery.
Talkman A500/T5 VMT Accessory Specifications
Operating Temperature
Storage Temperature

Positioning the Talkman A500/T5 VMT

• Determine the best position for the device and all the associated components. If a similar device was previously
installed, check to see if the position it used is suitable for the device.
• Test the installation for at least 30 minutes before installing on another vehicle. Record all details:
• Check that the position of the device does not obstruct vehicle controls.
• Check that the device does not obstruct the driver's view.
• Check the position of the device for user comfort over long periods.

Install the Mounting Brackets

Warning: The device must be mounted in accordance with accepted aftermarket practices and materials
supplied by Honeywell and/or RAM Mounting Systems. Honeywell does not support Talkman devices which
Figure 70: Clamp Mounting
Figure 72: Power Supply
-30° to 50° C (-22° to 122° F)
-40° to 70° C (-40° to 158° F)
| Talkman T5 Series | 116