Care And Use Of Headsets And Microphones - Honeywell Vocollect Hardware Reference Manual

Parameter
SrxPersistAutomaticPairing
PersistSrxPairingAcrossPowerCycle A700,
SrxSupervisorAudioEnable

Care and Use of Headsets and Microphones

The headsets and microphones used with the Voice system are delicate pieces of electronic equipment. Proper care
and use of these products will ensure that they work well for a long time.
Important: For maximum hygiene, Honeywell discourages sharing headsets among operators.
The design of the SRX2 Wireless Headset features an electronics module that can be removed from the
headband and windscreen. The electronics module can be shared among operators over multiple shifts,
providing some level of hygiene while potentially reducing costs.
Supported Description
Devices
A500, T5- Enables a device to remember the
Series, last automatically paired headset
Psion, after it has powered down. Upon
Intermec powering up, the device attempts
to connect to that headset instead
of going into pairing mode.
This parameter is replaced
by PersistSrxPairing-
AcrossPowerCycle as of
VoiceCatalyst 2.0.
When the device is placed into
a charger, the pairing will still
clear as in normal functionality.
This parameter is ignored if the
SrxAutoPairEnable configurable
parameter is disabled.
Persists all types of pairing when
A500 device is powered off.
This parameter replaces
SrxPersistAutomaticPairing as of
VoiceCatalyst 2.0.
A700, Enables/Disables the ability to
A500, T5- listen in on both sides of the SRX
Series, Wireless Headset conversation
Motorola through the use of a remote
listening kit or wired headset
plugged into the device.
Due to increased bandwidth
required by Supervisor Audio
mode, headset audio performance
may sound degraded while
Supervisor Audio is enabled. For
optimal performance, be sure the
parameter is set to "0" (disabled)
during all regular SRX wireless
headset use.
| Honeywell Wireless Headsets | 215
Values & Setting Location
0 = disabled
1 = enabled
Set in VoiceConsole > Device
Profile
0 = enabled
1 = enabled, for manual
pairing or pairing through
VoiceConsole
0 = disabled (default)
1 = play mixing of TTS and
mic data
2 = play the TTS audio only
Set in VoiceConsole > Device
Profile