About Led Indicators; A700 Device Led Indicators - Honeywell Vocollect Hardware Reference Manual

Note: The beep that signals a scan is enabled by default but can be disabled by setting
EnableBeepOnBarcodeScan to 0. The beep volume is controlled by the device volume and can be adjusted
with the Plus (+) and Minus (-) buttons on the device.

About LED Indicators

Vocollect Talkman devices, SRX and SRX2 headsets, and their chargers have LEDs that indicate the state of the
equipment. These LEDs may be on, off or blink. In some cases an LED will blink, alternating between two colors.
If the LEDs indicate that there is a problem, refer to information on troubleshooting to solve the problem. See also
Troubleshooting Problems Indicated by

A700 Device LED Indicators

The Talkman A700 products have several LED indicators to inform you of different states. The indicators and their
blinking patterns are described in the following sections:
Device State Indicator
The device state indicator is a ring that is divided into a larger and smaller segment:
Color
Off
Green
Green
Green
Green
Yellow
Yellow
Yellow
Yellow
Yellow
Yellow
Yellow
LED.
Figure 11: Ring Segments on Device State Indicator
Blink Pattern
Off
Small segment pulse
Small segment on
Solid ring
Fast blink
Rotating ring
Rotating ring
Rotating ring
Rotating ring
Solid ring
Small segment pulse
Small segment on
Device State
Off
Sleep
On
Charging complete
Touch Config or TouchConnect
successful
Loading or changing operator
Loading or changing task
Loading or changing voice
Starting up
Charging
Platform is loaded, but no task
loaded
TouchConfig sender mode entered
| Talkman A700 | 69