T1 10-Bay Combination Charger Power Supply Specifications; T1 10-Bay Combination Charger Wall Mount - Honeywell Vocollect Hardware Reference Manual

Operating Temperature
Storage Temperature
Humidity
Note: Packaging varies for product shipments. Generally, packing materials are about 15% of the total
shipment weight.

T1 10-Bay Combination Charger Power Supply Specifications

Input
Output

T1 10-Bay Combination Charger Wall Mount

This unit provides a convenient surface for mounting five charger units and their associated power supplies on a wall.
Customer assembly required.
• Honeywell recommends that the charger have a minimum of 12 inches of clearance above it for placement and
removal of the devices. Do not install another charger directly on top.
• The lowest anchor for each extrusion must be a minimum of 12 inches from the floor.
• Honeywell recommends using #8 pan head sheet metal screws of appropriate length into the center of the wall
studs. The clearance between the bottom of the screw head and mounting surface should be approximately 3/16 of
an inch.
• Install the battery charger so that the supporting surface and installation will safely support the weight of a fully
loaded charger, greater than 8 pounds.
• If wall stud mounting is impractical, Honeywell recommends using wall anchors that are capable of supporting at
least 10 lbs/anchor.
• The installer must verify the charger is removable from the wall without use of a tool.
CAUTION:
• Injury to persons and damage to the wall may result if the charger or mounting hardware is pulled from the
wall. To reduce the likelihood of such an injury, mount only on a surface that is structurally sound.
• Customer assumes all responsibility for the installation of these units.
• Be aware of potential hazards (electrical wires, waterlines, etc.) when drilling the pilot holes.
• Avoid blocking power outlets and other wall receptacles when installing the extrusions and charger unit.
Installing the T1 10-Bay Combination Charger Wall Mount
The following parts come with the T1 10-Bay Combination Charger Wall Mount:
Item #
1
2
3
4
5
6
32° to 122° F (0° to 50° C)
-40° to 158° F (-40° to 70° C)
95% non-condensing
Input Voltage: 100-240 Vac
Input Current: 2.4 A
Line Frequency: 50-60 Hz
Output: 80 W (12 V DCx 6.67 A)
Quantity
1
2
2
2
8
8
Description
Charger Stand
Phillips screws
Rubber feet
Extrusion
Self-drilling screw anchor #8
Washer, #8, flat, type B regular
| Chargers | 235