Honeywell Vocollect Hardware Reference Manual page 200

Sharing the SRX-SL Headset
By separating the parts of the modular SRX-SL headset, operators can share electronics modules in a multi-shift
operation.
• The electronics module detaches easily from the headband.
• The electronics module can be disinfected with an alcohol wipe.
Pair the SRX-SL Headset Using Bluetooth
The SRX-SL enters pairing mode as soon as it is powered on.
• The headset is then discoverable and connectable.
• The headset does not automatically reconnect with the last device (or devices) it was paired with previously.
• Once the SRX-SL headset is powered on, initiate the discovery and pairing process on the computer to which the
headset will be connected.
If the SRX-SL headset is not connected, it powers off after 10 minutes in the disconnected state to preserve battery
life.
If the USB cable is attached to charge the internal battery, the SRX-SL headset disconnects (if connected) and battery
charging begins.
Initiate paring on the device to pair with the SRX-SL headset.
Pair the SRX-SL Headset Using Near Field Communication (NFC)
The SRX-SL enters pairing mode as soon as it is powered on.
If the SRX-SL headset is not connected, it powers off after 10 minutes in the disconnected state to preserve battery
life.
If the USB cable is attached to charge the internal battery, the SRX-SL headset disconnects (if connected) and battery
charging begins.
1. Make sure the SRX-SL headset is on and is in pairing mode (the LED is solid green).
2. Locate the NFC tag in the headset eModule under the Power button.
3. Hold the NFC tag on the eModule close to the back of the A700 device. It may be necessary to move the eModule
up and down the back of the device to get the NFC tag close to the NFC radio in the handheld device.
| Honeywell Wireless Headsets | 200