Wearing The Sr-15 Behind-The-Head Headset; Removing The Sr-15 Headset Adjustment Strap - Honeywell Vocollect Hardware Reference Manual

Drop Tested
Enclosure rating
Humidity
Noise Reduction Rating
Note: Packaging varies for product shipments. Generally, packing materials are about 15% of the total
shipment weight.

Wearing the SR-15 Behind-the-Head Headset

1. Loosen the cable at the headband cord clip on the back of the headband to allow enough slack to move the speaker
away from the earloop.
2. Adjust the nylon band on the adjustment strap so that it lies flat against the headband of the headset.
3. Grasp the headset's ear loops and spread them slightly apart.
4. Place the headset behind your head, and slip the ear loops over your ears.
5. Adjust the headset's speaker so it fits snugly over your ear.
6. Place the microphone at the corner of your mouth. Position the microphone as close to your mouth as possible,
but outside of your breath stream. It should be facing your upper lip, and not touching anything (for example,
clothing, skin, or facial hair).
7. Clip the headset cord to your shirt or jacket where it is comfortable.
8. Let the cable fall down your back, and clip it to the belt near the device. If you are using a device cover, we
recommend that you clip the bottom clip directly onto the cover.
9. Adjust the nylon adjustment strap on the back of the headband so that it fits firmly, but comfortably, against the
back of your head. The nylon band can be adjusted by sliding the plastic buckle.
10. Connect the headset to the device.

Removing the SR-15 Headset Adjustment Strap

1. Align the keying rib on the plunger with the slot in the barrel.
2. Push the plunger all the way down until the plunger top lip contacts the top of the barrel, making sure the keying
rib is inside the keying rib slot.
3. With the plunger pressed all the way in, pull the adjustment strap clip to remove it from the headband.
• 15 drops from 7 feet (2.1 m) at minimum and
maximum operating temperatures
• 50 drops from 6 feet (1.8 m) at minimum and
maximum operating temperatures
Meets IP67
5-90% condensing
Not applicable
Figure 104: Keying Rib and Slot
| Honeywell Wired Headsets | 156