Charging A T2 Series Device - Honeywell Vocollect Hardware Reference Manual

Temperature: -20°C to 50°C (-4°F to 122°F)
Humidity: 95% non-condensing
Rain/dust: IP67
Battery Notifications
Battery warnings for a Talkman battery occur at the following levels:
• First warning = 3,550 mV
• Critical warning = 3,350 mV

Charging a T2 Series Device

1. Make sure the charger is powered. The charger's orange power light (LED indicator) is lit when the charger is
powered.
2. Sign off of the device if necessary.
3. Press and hold the yellow play/pause button until the LED indicator turns solid red and then turns off.
Note: It is not necessary to turn the device off before placing it into the charger.
4. Remove the device from the belt clip.
5. Disconnect any other peripherals. If the device is in a cover, remove the cover.
6. Insert the device into one of the device charger slots with the button controls of the device to the top and facing
toward the left.
CAUTION: Do not attempt to place the device into the charger unless you have first disconnected the
headset and any other peripheral devices. Do not remove the battery from the device when placing the
device into a charger.
7. After the device has been placed into the charger, make sure that the LED indicator on the device turns on and
begins to blink green.
a) If the LED does not turn on after 30 seconds, remove the device from the charger slot and then place it into the
slot again.
b) If the LED indicator still does not turn on, try another charger slot.
Figure 89: Inserting a T2 Series Device Into a Charger
| Talkman T2 Series | 132