2. Plug the other end of the cord into the AC adapter provided with the charging cable. The LED lights solid red
while charging.
3. Allow the SRX-SL headset to charge a minimum of three hours before first use. It may take up to three hours to
fully charge. The LED lights solid green when charging has completed.
4. Unplug the SRX-SL headset from the cord.
5. The SRX-SL headset is powered down when removed from the charging connection.
6. Press the Power button for at least ½ second. The SRX-SL headset powers on and is ready for use.
Charging Fault
If the
LED and Tones
(see page 273) indicate a charge fault:
•
Unplug the SRX-SL headset from the charging cable and plug back in.
•
Verify the temperature is within the safe charging range for normal charging: 32°F to 104°F (0°C to 40°C). If not,
move the headset to a different area and allow it to heat or cool to an allowable charging temperature.
•
If the fault persists, contact
SRX-SL Fast Charge
If the temperature is 32°F to 95°F (0°C to 35°C), the SRX-SL supports fast charging. Fast charging provides 75% of
the battery capacity in less than one hour of charging.
•
If the temperature rises above the fast charge threshold (95°F or 35°C) the SRX-SL headset reverts to normal
charging as long as the temperature stays below 104°F or 40°C.
•
The 75% capacity is measured from a battery that has reached the point of software shutdown voltage.
Not all chargers support fast charging. For best results use the Honeywell supplied charger. A computer port may
provide sufficient power for fast charge. An Apple charger may not support fast charging.
Assemble the SRX-SL Headset
The SRX-SL headset consists of an eModule (electronics module) and a headband.
Align the notches on the eModule and the headband and snap together.
Customer
Service.
| Honeywell Wireless Headsets | 199