Srx Battery Charger Wall Mount - Honeywell Vocollect Hardware Reference Manual

SRX Battery Charger Wall Mount

This unit provides a convenient surface for mounting the SRX battery charger and its associated power supply on a
wall.
• Customer assembly required.
• Customer assumes all responsibility for the installation of these units.
• Avoid potential hazards (electrical wires, waterlines, and similar building components) when drilling into the wall.
• Avoid blocking power outlets and other wall receptacles when installing the charger.
• Anchoring a wall mount to a wall stud generally results in a more stable installation. If you drill into a wall stud,
do not use a screw anchor in that hole.
• Anchors must be at least 12 in. (30.48 cm.) from the floor to allow for proper attachment, seating, and removal of
the charger unit.
SRX Battery Charger Wall Mount: Mounting the SRX Single-Bay Battery Charger
Honeywell recommends storing the single-bay charger on a desktop, but it can also be mounted on a wall.
Important: In order to mount the single-bay charger on a wall, the stand on the bottom of the charger must
be reversed.
1. Turn the charger over and loosen the screw on the bottom of the stand.
2. Flip the stand over and reinstall the screw.
3. Drill two pilot holes for wall anchors (not included). The anchors should be spaced 2.75" apart vertically.
4. Install the anchors and screws (not included).
5. Be sure to use both the keyhole slot and screw slot to hang the charger.
SRX Battery Charger Wall Mount: Mounting the SRX 5-Bay Battery Charger
Parts List:
• 4 self-drilling screw anchors #8
• 4 screws, #8 x 1.5 Phillips pan head
You will need:
• Drill with 1/8" bit
• Screw driver, #2 Phillips
1. Mark the location of the anchor holes on the wall, spaced 9" apart horizontally and 2" apart vertically. Make sure
that the bottom anchor holes are at least 12 inches from the floor and level.
2. Drill the pilot holes for the anchors, insert anchors and screws. Leave screw heads sticking out from the wall.
3. Insert the power supply into the back of the charger as shown. Plug the power supply into the charger but do not
plug it into a power source until after mounting is complete.
4. Hang the charger on the screws by lining up the keyhole slots on the back of the charger with the screw heads on
the wall.
Figure 172: Power Supply Plugged into Charger
| Chargers | 240