Removing A Battery From A Talkman A700 Device; Scanning With The Talkman A730 Device - Honeywell Vocollect Hardware Reference Manual

1. Hold the Talkman so that the battery compartment is facing up.
2. Hold the battery with the rounded side up.
3. Place the battery in at an angle, pins end first.
4. Push the back of the battery into place.
You will hear a click when the battery is in place.
CAUTION: Do not force the battery into the compartment. You may damage the battery or the device. If
the battery does not snap easily into place, reposition the battery in the compartment and try again.
Make sure the battery is firmly in place and can't be removed without pressing the battery release button.
Warning: Replace a battery only with another battery that has been authorized by Honeywell for the product
you are using. Use of an unqualified battery may present a risk of fire, explosion, leakage, or other hazard.
See also Honeywell Battery Safety

Removing a Battery from a Talkman A700 Device

Make sure the Talkman device is off.
CAUTION: Do not remove the battery until the LED indicator is off. If you remove the battery when the
device is on or sleeping, any data collected could be lost.
1. Hold the device in one hand.
2. Press the battery release button all the way down until the top of the battery pops out from the battery
compartment.
3. Lift the battery out of the compartment.

Scanning with the Talkman A730 Device

See the Compliance Section of this document for Laser and Imager Compliance and Precaution information.
The scanner can only be used at points in the task where it is allowed, such as a check digit or product verification
prompt.
1. Hold the Talkman A730 in a "handshake" grip with the scanner pointing away from you.
2. Position the device so that the scanner is 4 to 36 inches away from the barcode you want to read. Note that scan
accuracy may decrease at greater distances.
3. Press and hold the round black button to activate the scanner.
4. Direct the lighted aiming frame so that it completely contains the barcode.
5. When a scan is successful, the aiming frame will turn off and you will hear a beep in the headset.
Figure 10: Removing the Battery From a Device
| Talkman A700 | 68