Honeywell Vocollect Hardware Reference Manual page 214

Parameter
SrxAutoPairEnable
SrxClearPairingInCharger
SrxHeadsetEnable
SrxHighPowerPairingDelaySeconds A700,
Supported Description
Devices
A700, Enables automatic pairing mode
A500, T5- on SRX and SRX2 headsets.
Series
This parameter is not applicable
for third-party handheld devices.
A700, Gives the user the ability to
A500, T5- force devices to clear the headset
Series, Bluetooth pairing from memory
Psion, when placed into a charger.
Intermec
If SrxAutoPairEnable is on, this
defaults to 1 as well to clear
pairings when placed into the
charger.
A700, Enables/disables use of SRX or
A500, T5- SRX2 wireless headsets with
Series approved Bluetooth devices.
Users may prefer to disable
headsets when using other
Bluetooth peripherals.
SRX headsets: Specifies how
A500, T5-
long (in seconds) an operator
Series,
is required to hold the plus and
Psion,
minus buttons on an SRX headset
Intermec,
while in low power pairing mode
Motorola
before entering high power
pairing mode.
SRX2 headsets: This parameter
specifies if the operator is
required to press the plus and
minus buttons on an SRX2
headset while in low-power
pairing mode to enter high-power
pairing mode.
| Honeywell Wireless Headsets | 214
Values & Setting Location
0 = disabled
1 = enabled
The default setting depends
on the version of Vocollect
Voice software implemented.
If this parameter is set to
1 (enabled), the setting of
SrxClearPairingInCharger is
ignored
Set in task package, operator
profile, device profile, or VRG
file
0 = disabled
1 = enabled
If you enable this parameter,
the SrxAutoPairEnable must
be set to 0 (disabled).
Set in VoiceConsole > Device
Profile
0 = disabled
1 = enabled
Set in VoiceConsole > Device
Profile
SRX headsets: 1 to 10
seconds
(default is 6)
Value can be 0 when AutoPair
is enabled for headsets.
Set in VoiceConsole > Device
Profile
SRX2 headsets: 0 = the
headset enters high-power
pairing mode when the SRX2
headset is turned on.
any other setting = the
operator must press the plus
and minus buttons on an
SRX2 headset to enter high-
power pairing mode.
Set in VoiceConsole > Device
Profile