Supervisor Audio With Srx/Srx2 Headsets; Configuration Parameters For Srx/Srx2 Headsets - Honeywell Vocollect Hardware Reference Manual

• Use a pairing mode that is not as susceptible to cross pairing - avoid using auto pairing.
• Ensure that users are isolated by some distance when the devices perform inquiry searches.
• Use manual pairing, rather than auto pairing, so that the searches are done only at the user's request.
• Use low power pairing.
• If your users do not share headsets and devices, use manual pairing so that the device and headset remain paired.
• If your users share headsets and devices, use auto pairing so that pairing hardware at each shift will complete
faster.

Supervisor Audio with SRX/SRX2 Headsets

Supervisor Audio is a feature that will allow a second party to listen to the conversation between a Bluetooth-enabled
device and a user with an SRX or SRX2 headset.
A supervisor wears a wired headset connected to the operator's device, then walks behind the operator who is wearing
a wireless headset paired with the same device. The supervisor must keep the operator's device within range of the
operator's wireless headset.
Note: This feature is designed to work with Vocollect Talkman devices. It may function properly with other
devices depending on the available processing power. See the release notes for Vocollect Voice software and
your device.
Supervisor Audio offers two listening modes.
• Combined audio - the user's microphone audio and the text-to-speech (TTS) audio are combined and streamed out
of the wired audio port
• Device audio only - the TTS audio only is streamed to the second party
Enabling Supervisor Audio
To enable this feature, set the SrxSupervisorAudioEnable configuration parameter to the desired mode. See

Configuration Parameters for SRX/SRX2 Headsets

• This feature should ONLY be used for debugging and when a user requires training or assistance. This parameter
should be turned off for optimal performance.
• Under normal operations, you cannot have a wired headset attached to the device when using an SRX or SRX2
headset. This parameter overrides this requirement when enabled.
• To avoid disconnecting the wireless headset, pair and connect the device to the headset first, then connect a wired
headset.
Configuration Parameters for SRX/SRX2 Headsets
Parameter
Bluetooth_IsEnabled
for details.
Supported Description
Devices
A700, Determines whether the
A500, T5- Bluetooth portion of the radio is
Series receiving power.
When the value for this setting
is set to false, the Bluetooth
portion of the radio receives no
power, and no other Bluetooth
parameters are active.
| Honeywell Wireless Headsets | 213
Values & Setting Location
True
False
Set in VoiceConsole > Device
Profile or Edit Device