Wearing An Srx2 Wireless Headset - Honeywell Vocollect Hardware Reference Manual

| Honeywell Wireless Headsets | 182
Figure 127: Battery Latches for Removing SRX2 Battery
3. With your other hand, hold the battery at the end of the electronics module opposite the mic boom.
4. Press and hold both battery latches at the same time, squeezing them into the sides of the electronics module until
the battery releases from the electronics module.
SRX2 Battery Warm-Up Time
If a battery has been used in an extreme hot or extreme cold environment, charging will not start immediately.
When the battery is placed in the charger, the battery port LED indicator will turn yellow. Charging will only begin
after the battery reaches the proper temperature range - 32° F (0° C) to 104° F (40° C). It may take up to 30 minutes
for the battery to reach a safe temperature.
If battery temperature does not come into range in about one hour, the red LED will blink indicating that there is a
charger fault.

Wearing an SRX2 Wireless Headset

1. Put the headset on and adjust the ear pad to fit snugly over your ear.
Figure 128: Wearing the SRX2 headset
2. Position the t-bar directly above, and as closely as possible to, your other ear.
3. If installed, adjust the stability strap so it fits securely across the back of your head.
4. Rotate the electronics module up or down to position the microphone near your mouth.