T1 10-Bay Combination Charger; T1 10-Bay Combination Charger Specifications - Honeywell Vocollect Hardware Reference Manual

Left Indicator Color
Blinking Red
Blinking Red, then Off
Blinking Yellow
Yellow
Yellow

T1 10-Bay Combination Charger

• The T1 10-Bay Combination Charger can store five devices at a time.
• The charger can store and charge ten batteries at a time - five batteries in the lower battery slots and five batteries
connected to devices in the upper device slots.
• A T1 device should not be placed into a device charger without a battery attached to it.
• The socket-outlet should be installed near the equipment and should be easily accessible.

T1 10-Bay Combination Charger Specifications

Length
Depth
Height
Power
Weight
Cord
Right Indicator Color
Off
Blinking Green, then Off
Off
Green
Off
Figure 167: T1 10-Bay Combination Charger
If a device with a battery is the charger...
The battery may not be inserted into the charger
correctly.
If the LED continues to blink red after inserting the
battery into the charger correctly, troubleshoot the
charger.
The battery is defective. Remove the battery from the
charger and give it to your system administrator.
Troubleshoot the problem
This will occur briefly when a battery is removed from
the charger. If the LEDs stay on for a length of time,
troubleshoot the problem.
The battery may not be properly inserted into the
charger.
The battery may be too hot or too cold. Wait for the
battery's temperature to normalize.
If the yellow LED remains lit for more than two hours,
troubleshoot the problem.
21.9" (55.6 cm)
3.7" (9.4 cm)
5.9" (15 cm)
Input Voltage: 12 V DC
Input Current: 5 A maximum
70.5 ounces (2000 g)
Uses standard IEC 60320 plug
| Chargers | 234