Led And Tones - Honeywell Vocollect Hardware Reference Manual

Desired Action
Power On
Power Off
Volume Up
Volume Down
Start voice recognition
application on the
connected device
Disconnect, cleared paired
devices, enter pairing mode
Answer call
Reject call
Hang up call
Transfer audio
Mute/Unmute microphone
Connect to last device
Reset headset (restarts the
headset in the rare event
the SRX-SL headset has
become unresponsive)

LED and Tones

The SRX-SL contains a single LED that signals events to the user. The LED is accompanied by tones to signal these
events when the headset is being worn.
Use Case
Pairing mode, default state
at power up.
Powering off
Normal operation
Pairing Failure
Button
Power button
Power button
Volume Up button
Volume Down button
Power button
Volume Up and Volume
Down buttons
Power button
Power button
Power button
Power button
Mute button,
Power button
Power and Mute buttons
SRX-SL State
Discoverable and
Connectable.
Off
Paired and connected.
Discoverable and
Connectable
Press Action
Press and hold for at least
½ second
5 seconds
Momentary
Momentary
1 second
Momentary
Momentary
1 second
Momentary
1 second
Momentary press, or rotate
the boom up 90° to mute,
rotate the boom down 90°
to unmute
Momentary
5 second
LED
Solid green
Solid green for 1 second
then all off.
Flashing blue.
Flash frequency is 1.5
seconds
On 20%, off 80%.
Solid Green
| Honeywell Wireless Headsets | 195
Valid In These SRX-SL
States
Off
All except Off
All except Off
All except Off
On, paired and connected,
no active call, voice
application, or A2DP
stream,
All except Off
Incoming call
Incoming call
Active call
Active call
Active call or voice
application
On and paired, but not
connected
All except Off
Tones
High-pitch double beep at
power up
Low-pitch double beep
atpower off
Three ascending tones on
connect
Long low-pitch tone